Groups
Community
Welcome to our vibrant online community, where we encourage members to share their personal experiences and insights to foster collective growth and mutual support in our journey towards well-being.
Wall post
Replies
B
Hello, 1st time user with Glowing IC Pad. I set up transfer from my computer, only got sound and no lights. Then I tried transfer from my iPhone and only got lights, but no sound. Did the transfer work? Thank you
0
8 Comments
Aug 19, 2021
Hi Bart, if IC Pad is connected correctly, there should be lights and no sound. If using a computer, after connecting IC Pad please check your audio setting, you may need to change the Output device to "headphones".
1 reply
Hide branch
RS
Aug 23, 2021
Hi Anton Sheikh-Fedorenko, I have just connected my phone to the glowing IC pad. A message popped up on my phone and asked me to select โHeadphonesโ or โotherโ. I selected other (before reading this comment and reading all the instructions I could find online regarding setting up where this... See more
1 reply
Hide branch
Aug 24, 2021
Hi Rebecca, you can try to restart the phone with a disconnected IC Pad and then try again. Also, you can try following
1) If your iPhone is running iOS 11 or newer, open Control Center by swiping up from below the bottom of the screen. Then, press and hold... See more
2 replies
Hide branch
RS
Aug 25, 2021
Hi Anton Sheikh-Fedorenko, thank you for your reply. I followed these steps and the IC pad still does not light up when my phone is connected and โheadphonesโ now selected in settings. Iโm yet to see it work at all or try it yet.
2 replies
Hide branch
Aug 25, 2021
Hi Rebecca, once connected, please, make sure the audio volume is set to the maximum during the transfer: 1) Connect IC Pad. 2) Start transfer 3) Check that audio volume is set to maximum on your phone.
0 replies
Hide branch
DB
Oct 05, 2021
This may sound like a silly question but have you fully charged the glow pad? People will sometimes forget to plug their glow pad in and charge it just like our cell phones so keep it fully charged and you shouldn't have any issues. Hope this is helpful.
Rebecca Smith,
0 replies
Hide branch
Wall post
Replies
eh
Dear Anton my Glowing IC Pad doesn't light up during the transfer, although In my laptop screen I can notice the frequency line . Is there any problem?
0
2 Comments
DB
Oct 05, 2021
Hi I experienced the same issue and realized I needed to plug in the charging cord into the IC Glow Pad and after it was fully charged I resumed uploading ICs to my water. I now keep my Glow Pad plugged into the charging cable al the time. Hope this helps.emil hurezeanu,
0 replies
Hide branch
Oct 03, 2021
Dear Emil, please try to use another browser, I just tried with Safari and it indeed works strangely, maybe some new safari update has bugs. With Chrome works as expected. Also, make sure the audio volume is set to maximum during the transfer
0 replies
Hide branch
open modal
Thank you very much,
your experience has been submitted!
your experience has been submitted!
Done
Please select language
Select