Has the team found any research that suggests the PEMF device can transfer frequencies to crystals?
We have not studied crystal imprinting; however, some people have imprinted crystals, and the results have been positive.
Is there a higher level of effectiveness to use drops (Method 2) versus charging an entire bottle of water (Method 1)?
Both Method 1 and Method 2 are similar in terms of efficacy, but because it is important to use ICs regularly, we recommend using the method that is most convenient for you.
Can the Glowing IC Pad be used for PEMF protocols? Is it efficient to use it to transfer ICs to water? Or should I apply it to the body?
The Glowing IC Pad can be used to transfer PEMF ICs to water as well as directly to the body. However, the best way to use PEMF ICs is to apply them directly to the body. Please see details on different application methods here.
Is there a limit to how many ICs/complexes that can be added to one bottle or glass of water before it becomes ineffective?
The number of ICs that can be added to one bottle or glass of water depends on the person’s health and energy state. For some, 10 or more ICs works well; however, this is not the case for everyone. On average it is recommended to start with up to 6 ICs per bottle or glass. Depending on how you feel, you can increase (or decrease) the number of ICs.
With respect to IC Complexes, it is recommended that you do not transfer more than one IC Complex to a bottle of water - you should transfer IC Complexes into separate volumes of water and then drink them one after the other (at least 10 minutes apart).
How much IC water should I drink and how often?
For imprint ICs, it is recommended to drink at least 50 mL (2 oz) of IC water at least 3 times a day. For best results, try drinking the IC water on an empty stomach and hold the water for 10 seconds in your mouth before swallowing.
Do we need to shake the bottle after the transfer of IC?
You do not need to shake the bottle after IC transfer - the bottle should be vigorously shaken before the transfer. However, for Method 1, when you finish half of the prepared IC water, you may add new water to your bottle and vigorously shake it for at least 10 seconds.
Can I transfer ICs only to water?
No, you can transfer ICs to other products including but not limited to pre-made drinks, dairy products, lotions, and creams.
What water temperature should I use to transfer ICs? Can I use IC water for cooking or bathing?
To transfer ICs, you should use water that has a temperature below 30C (86F) and above 2C (36F). Thus, you cannot transfer ICs directly into hot beverages or soups. You can use IC water for cooking and bathing; but, the temperature should not exceed 30C, otherwise, the water molecules will have too much energy and the coherent domains (which carry the frequencies) will be destroyed. Therefore, you can use IC water only for cold dishes/beverages or in a slightly warm bath.
Are there any side effects from using ICs?
There have been no reports of negative effects from ICs. If an IC is not right for you, it will not resonate with your body and thus will not affect you. Some people may notice mild body pain during the first few days of using ICs, which is normal and practitioners interpret this as the start of the body’s healing process using the newly acquired information. If you have any concerns, please contact your practitioner.
There are a lot of ICs based on homeopathic or natural remedies that can be used for both people and animals; however, are often advised for “people” only? Why is that?
A lot of the original remedies are primarily developed for people and therefore it is specified for people.
Can ICs be transferred to Kangen water?
Yes, ICs can be transferred to Kangen water.
Can I run a PEMF program more than once in one sitting?
Yes, you may repeat a PEMF program more than once in one sitting. There is no limitation since it is based on the individual and their body system. Some people may find that 3 repeats are great for them, while others may feel it’s too much. Nevertheless, it is generally suggested that you focus on a maximum of three specific health issues at a time.
Do EMFs in your house affect the IC water?
EMFs affect water – the closer it is to the source, the stronger the effect. To avoid EMF interference, you may use IC Capsules.
What is the maximum volume of water I can imprint at one time?
The maximum volume of water you can imprint at one time depends on the IC transfer device. For the Circuit IC Pad, you can imprint up to 0.75 L, while for the Glowing IC Pad and IC Hummer, you can imprint up to 2.0 L at one time.
Is there an Infopathy App available?
There is no Infopathy App currently available; however, we are developing one at the moment.
Can I put water in a metal cup (such as aluminum or stainless steel) after IC transfer?
After you prepare your IC water in a glass (or plastic) container, you can transfer it to a metal cup.
What type of bottle (in terms of material) should I use to make IC water? Can I use stainless steel bottles?
The best bottles to use when making IC water are glass bottles. Stainless steel bottles cannot be used to make IC water since the metal shields the electromagnetic signal produced by the IC Pad. If you would like, you can prepare your IC water in a glass bottle and then transfer it to a stainless steel bottle.