30 Hz (Hulda Clark)
By selecting your device, the default minimum transfer time will be set.
Add to Complex
Primary Application
PEMF
Source
Algorithm
30 Hz frequency will run for 7 minutes and then 20 minutes with no signal (break). You can set a few repeats if you would like to achieve the following: 7 minutes of 30 Hz -> 20 minutes break -> 7 minutes of 30 Hz -> 20 minutes break -> and so on.
Similar ICs
476
10.8 k
PEMF
A clinical study and experiments with animals have shown that bathing patients in flashing light pulsating at a frequency of 40 hertz might reverse...
676
24.8 k
PEMF
This PEMF was created to help heal wounds. It can be used daily until the wounds are getting better. Always seek medical care if you have severe pr...
107
6.91 k
Imprint
It is the remedy for any fear whose cause can't be named. At one end of the spectrum, the Aspen fear may be no more than a sense of foreboding, an ...
Please select language
Select