Hi My glowing IC Pad3 will not connect to bluetooth on my phone. I have other devices I use with bluetooth no problem. Has been working fine and worked this morning but would not connect in the afternoon. It will work when plugged into my computer. I unpaired it as suggested but now won't pick it up at all. Says no devices found when scanned. Any advice?
Community
Welcome to our vibrant online community, where we encourage members to share their personal experiences and insights to foster collective growth and mutual support in our journey towards well-being.
Wall post
Replies
DV
I have a general question - sometimes I will have to reload the IC once I am halfway through. Is there a way to fast forward so I can get to the same point without starting all over again?
4
2 Comments
May 22, 2024
1 reply
Hide branch
0 replies
Hide branch
Wall post
Replies
AS
Alyssa Shepherd
about 1 year ago
Hi - what would be suggested for an apparent infection of a toe. Very minor break in the skin. Red. Swollen. Painful. Seems to peak in symptoms around 3 a.m.
PEMF and imprint suggestions please. (I donโt know the type of bacteriaโฆ and am assuming itโs bacterial - happened after a day at the beach with a very hot bath at the end.)
Thank you
Anton SF
PEMF and imprint suggestions please. (I donโt know the type of bacteriaโฆ and am assuming itโs bacterial - happened after a day at the beach with a very hot bath at the end.)
Thank you
1
0 Comments
open modal
Thank you very much,
your experience has been submitted!
your experience has been submitted!
Done
Please select language
Select
You can also watch this short video to learn on how to turn it back on: https://vimeo.com/944217062?share=copy
Or follow these steps:
1. Turn on IC Pad
2. Press and hold button for about 10 seconds. (keep holding even when white light goes off).
3. After 10 seconds indicator light will flash red. You can remove your finger and device will turn off.
4.... See more
You can also watch this short video to learn on how to turn it back on: https://vimeo.com/944217062?share=copy
Or follow these steps:
1. Turn on IC Pad
2. Press and hold button for about 10 seconds. (keep holding even when white light goes off).
3. After 10 seconds indicator light will flash red. You can remove your finger and device will turn off.
4. Turn on device and try to connect to your phone/tablet
Please make sure audio volume is set to maximum after starting the transfer.
Please let me know if that helped. Thank you!